Veneer Peeling Line-manufacture,factory,supplier from China

The demand for wood veneer dryer is increasing year by year,and it has been recognized and purchased by consumers.Traditional natural air-dried wood is prone to problems such as deformation and cracking.The use of wood dryer equipment can effectively solve this problem.The cost of dryer equipment is high, so basic maintenance needs to be done in the later use process,such as the ground,ventilation system, gate,instrument,heating system and debugging system,etc.The specific operations are as follows:1.The floor of the wood dryer equipment should be kept clean and tidy,and the debris should be c

Because the single board dryer is a long and large equipment, it is necessary to install the single board dryer in a correct sequence and method. The correct installation process is as follows:1. Draw the base line: make the cross line and elevation line correctly on the base plate.

Recently, the veneer dryer provided by our company was successfully installed in Cambodia and has been put into use. Our engineers go to the customer's factory to guide the installation and will not return until the equipment is running normally and the workers are skilled in operation.The high reliability and low failure rate of veneer drying equipment greatly reduces equipment maintenance and downtime, and improves the overall operating efficiency of the production line.

Because the veneer dryer machine is a long and large equipment, it is necessary to install the veneer dryer machine in a correct sequence and method. The correct installation process is as follows:1. Draw the base line: make the cross line and elevation line correctly on the base plate.

Recently, our veneer peeling machine and knife sharpening machine purchased by Uganda customers have been finished production and debugging,and are now preparing for shipment.Customers will soon receive the products as scheduled.The customer chose us after many investigations.Thank you very much for your trust.I believe you will not regret buying our equipment after receiving our products.

The four deck veneer dryer purchased by myanmar factory is used to dry rubber wood. The customer gives good feedback. It is used with the biomass burner.The biomass burner which as the heat source can provide high temperature to the dryer to make sure the sufficient heat impinged on the wet veneer in an efficient manner. At the same time, the tree bark from debarker and waste veneer from peeling lathe were burned as the fuel directly, which solved the waste accumulation in the veneer plywood making factory.

Shine roller veneer dryer machine finished the installation in Jiangsu Province. The 2deck veneer dryer was ready for the test running. When the veneer is peeled from the veneer peeling lathe, we will start the test running on the core veneer roller dryer and conduct the training on the workers of the user's factory.  

The veneer roller dryer module GTH30-30 two deck core veneer drying machine has finished the production and being trucked to customer's factory in Xuzhou, Jiangsu China. The installation is expected to take around 3-4 weeks. We wish veneer peeling factory make a good fortune this year.  

Roller Veneer Dryer is one of the most often used veneer dryers for drying core veneer in the plywood making process. After peeling, the fresh veneer is fed into the core veneer dryer. Through the press of the upper rollers and heating of the hot air sections, veneer is delivered to the cooling section and finally discharged at the outfeed of the veneer dryer. The veneer after drying has uniform moisture content and it is flat without buckle or end waviness.

Recently, a brand new veneer dryer from our company is being sent to the customer's factory. After many inspections, the customer finally chose us. We specially customize the production according to the customer's veneer size to ensure that the output of the veneer dryer meets the customer's production needs. It can be used to dry various wood species.